Measured in a laboratory environment at an ambient temperature of 25° C (77° F) with the Zenmuse S1 installed on the aircraft.
Ingress Protection Rating
IP54
Under controlled laboratory conditions, it can achieve an IP54 protection rating by IEC60529 standards. The IP rating is not permanently effective and may decrease due to product wear and tear.
Operating Temperature
-20° to 40° C (-4° to 104° F)
Storage Temperature
-20° to 60° C (-4° to 140° F)
Stabilization System
3-axis (tilt, roll, pan)
Angular Vibration Range
Hover: ±0.01° Flight: ±0.02°
Mounting
Detachable DJI SKYPORT
Mechanical Range
Tilt: -129° to +73° Roll: ±55.8° Pan: ±327°
Structural limit, not controllable range.
Controllable Range
Tilt: -120° to +60° Pan: ±320°
Operation Mode
Follow / Free / Re-center
Maximum Central Illuminance
35 lux @100 m (Both On mode)
Measured in a laboratory environment at an ambient temperature of 25° C (77° F) with the Zenmuse S1 installed on the aircraft.
Low Beam Central Illuminance
13 lux @100 m (Low Beam mode)
Measured in a laboratory environment at an ambient temperature of 25° C (77° F) with the Zenmuse S1 installed on the aircraft.
High Beam Central Illuminance
30 lux @100 m (High Beam mode)
Measured in a laboratory environment at an ambient temperature of 25° C (77° F) with the Zenmuse S1 installed on the aircraft
Effective Illumination Angle
15±1° (10% relative illuminance, Low Beam mode and Both On mode) 4±0.5° (10% relative illuminance, High Beam mode)
Typical Color Temperature
6500K typical value (Low Beam mode) 7500K typical value (High Beam mode)
Measured in a laboratory environment at an ambient temperature of 25° C (77° F) using an integrating sphere. Actual results may vary slightly due to different experimental conditions, and the final effect is subject to actual use.
Dimming Mode
Analog dimming
Effective Illumination Distance
500 m (Both On mode)
Measured in a laboratory environment at an ambient temperature of 25° C (77° F). Actual conditions may vary slightly due to specific environmental humidity, weather conditions, and other factors. The final effect is subject to actual use.
Lighting Control
Turning light on/off, brightness adjustment
Strobe Mode
5 Hz strobe
Lighting Mode
Low Beam mode, High Beam mode, Both On mode
Remote Controller Buttons
Can be set for turning the light on/off, brightness adjustment, or lighting mode changes
Gimbal Synchronization
Supports synchronized control with other gimbal-equipped payloads
Eye Protection
Automatically limits brightness to 40% when not in flight
Payload Protection
LED, LEP temperature protection, overcurrent protection, and power protection to prevent damage.